Special winder for charging pile of
new energy vehicle
DT-EV700
The total length of the output end
is 3-7M
AC220V 32A
Advantages of special winder for charging pile of new energy vehicle
1. Industry first 6.Universal conversion of double bridge wave slip ring
2. Pull and stop 7.High temperature protection
3. Pull and take 8. Atmospheric appearance
4. Damping buffer 9. Sun protection against cold
5. Damping buffer 10.Eliminate the disordered phenomenon of dirty, disordered
Charging reel adapts flexibly to all operating conditions. In the private and commercial sector as well as for the supply of entire vehicle fleets in the commercial vehicle sector and public service. Depending on the application, plug types, cables as well as the overall design of our charging reels vary. With regard to the application, the cable and plug can be supplied sidewise, from the ceiling or from below. The corresponding cable length is controlled by our charging reel. This allows a very variable spatial positioning to the charging location of the vehicle. Our charging reel is the ideal supply for individual vehicles or vehicle fleets
How to use it
When charging the new energy electric vehicle, the user pulls out the charging gun and
goes to the charging interface of the vehicle. At this time, because the wire clamping ball
of the winder clamps the gun wire, the user gently pulls the traction rope of the winder.
When the gun wire reaches the required length, the user only needs to pause for a
moment. The automatic locking device of the winder immediately works and locks the
traction rope. The user inserts the charging gun to start charging, After pulling out the
charging pile from the vehicle, the user gently pulls on the charging gun. At this time, the
automatic locking device of the winder immediately works and unlocks the traction rope.
The traction rope is automatically recovered under the action of the power spring of the
winder, and the wire clip ball and the gun wire are recovered to the outlet of the winder
(that is, the top of the charging pile column, the middle of the gun wire and the top of the
column, The gun wires at both ends are in free hanging state, and the charging gun is
inserted into the reset position, so that a work cycle process ends.)
